Set the voltage and current your application needs. The Smart Panel works out the power and points you to the right Microswitch model — in real time.
Reliable power solutions, from the wall-mounted rectifier to the 6000 A modular cabinet.
Wall-mounted rectifier · 1000A – 12V
Cabinet rectifier · switch-mode technology
Up to 6000 A · Twin technology
A rectifier does not treat the parts: it supplies the regulated direct current your line needs. Here are the processes powered by our rectifiers on our customers' sites.
Anti-corrosion zinc deposit on steel parts, in a tank or in a barrel.
See the page →Nickel deposit for wear resistance, dimensional build-up and finishing.
See the page →Thick chrome layers on parts subject to friction.
See the page →Controlled oxidation of aluminium to protect and colour it.
See the page →Immersion coating under current, for even coverage.
See the page →Gold, silver, palladium, rhodium: thin deposits where every micron counts.
See the page →The rectifier powers the bench and follows the test profiles of your equipment.
See the page →The 8 surface finishing processes covered by Micronics rectifiers.
See the overview →Worth remembering: the treatment itself takes place on your line, with your baths and your processes. Micronics designs, supplies and maintains the rectifier that powers it — and that is what determines how consistent the deposit is.
Four steps between your workshop mains supply and your installation.
Your installation is fed by the mains network, in alternating current. A treatment bath or a test bench, however, needs direct current.
The rectifier turns that alternating current into direct current, the only form your application can use.
You set a voltage or current setpoint. The electronics hold it continuously, despite variations in the load and in the mains supply.
The regulated direct current goes out to your equipment. Continuous measurement compares the result with the setpoint and corrects any deviation immediately.
A rectifier is rarely bought off the shelf: it is selected, configured, installed and maintained.
Process, voltage, current, environment, installation constraints: the right rectifier is chosen from your actual requirement.
Describe my requirement →02Control, metering, interfaces: your rectifier is configured for your installation, then assembled in our workshops in Villette-d'Anthon.
See the options →03Our technicians come on site for the connection, the settings and the handover to your teams.
On-site service →04Servicing, repair, genuine parts: your equipment stays operational year after year.
Repair & maintenance →Our experts support you from study through to commissioning.